Star Wars - AT-AP Walker as 3D large model
The All Terrain Personal Transport (AT-PT) was a light anti-infantry walker used by the Galactic Republic and, later, the Galactic Empire. It was manufactured by Rothana Heavy Engineering, a subsidiary of Kuat Drive Yards.
Made to take a single trooper into an intense combat situation on his own, it was the basis for the AT-ST and AT-AT.
AT-PTs were made to take single troopers into intense combat situations on their own, with the firepower of a squad. They stood only three meters tall, and were driven by AT-PT pilots.
The walkers were capable of reaching speeds up to 60 kilometers per hour and could climb a 45-degree angle, with hydraulic adjusters keeping the unit balanced.
The vehicles carried a long-range comm antenna for patrols.
The main drive unit provided power and hydraulic pressure for the two legs, and featured cooling vents.
The cockpit entry hatch was on the side, while the emergency flare launcher was just above the viewport.
The AT-PT was — compared to its intended threat, enemy soldiers — heavily armored, enough so that small-arms fire could not penetrate the craft's armor.
The walker was armed with twin blaster cannons and one concussion grenade launcher, which were only effective against infantry.
The walker's superior agility made up for its light armor (in comparison to most other cavalry units).
The units often traveled in packs for increased firepower.
AT-PTs were upgraded versions of Light All Terrain Personal Transports, and were constructed at Imperial mech factories.
Please note that this kit is not a toy and can only be played with to a limited extent. Please keep the items away from small children under the age of 6 years . It involves small parts which might break off and be swallowed. We declare the model as a puzzle or decoration.
Item Description:
Material: 4mm wood
Dimensions approx. ca. in cm: (L x W x H) 26 x 18 x 27
Weight approx: 0.8 kg
Content: 1 x lasered kit with 70 parts / assembly instructions
Supplied as a lasered kit. This must be assambled by yourself.
No tools needed. The parts must be glued.
The kit is made of wood and has been lasered. This will cause the edges to look burnt and possibly leave traces of soot and smoke on the wood. These can be easily removed with fine sandpaper.
All components are laser cut so that there is a "beautiful" front and a marked, production-related "bad" back. Make sure that the good side always points to the visible side.
These soot and smoke marks as well as the fact that wood is a natural product, which is dimensionally influenced by basic physical laws such as temperature and humidity, there are certain limitations in the nature of the products, which must be consciously accepted.
We offer the most careful choice of material and the most modern production methods, nevertheless one has to accept with wood the peculiarities and unimpeachable characteristics, which are to be observed again and again in the practice - therefore these can not be claimed by the buyer as a material defect.
