Fordson E83W Van 1952 as 3D large model
The Fordson E83W, (also sold from 1952 under the Thames brand as Ford Thames E83W), is a 10 cwt (half ton) light commercial vehicle that was built by Ford of Britain at the Ford Dagenham assembly plant (home of Fordson tractors) between 1938 and 1957. The van was sold in Australia as the Ford Ten-Ten, and the E83W was available in various forms around much of the world as Britain strove to export after World War II. In some countries, the 'cowl and chassis' only was imported and local bodies where built on it.
The E83W was aimed at the small haulage, trade and merchant market, sectors in which it sold well. An estate car variant was also available During and after World War II, many specialist variations such as mobile canteens, ice cream vans and even fire pumps were built on the E83W chassis.
The E83W was powered by the 1,172 cc (71.5 cu in) Ford 10 hp side-valve engine, with a 3-speed gearbox, and was heavily geared down in the rear axle. This made the Fordson much slower than the saloons, with an effective top speed of not much over 64 kmh (40 mph).
Apart from the 10 hp engine, the E83W shares few parts with the other small Fords, which does make spares a little harder to get hold of.
The front and rear axles are much heavier than the saloon and 5cwt van components, and share some parts such as bearings and other internals with the contemporary Ford V8 models (Models 62 and E71A Pilot). The headlamps were shared with the E27N tractor, for which they were an optional extra only.
Please note that this kit is not a toy and can only be used to a limited extent. Please keep the items away from small children under 6 years old. It involves breaking off small parts and being swallowed. We declare the model as a puzzle or decoration
Item Description:
Material: 4mm wood
Dimensions approx.: 62 x 29 x 28 cm (LxWxH)
Weight approx: 2.1 kg
Content: 1 x lasered kit with 209 parts / assembly instructions
Supplied as a lasered kit. This must be assembled by yourself.
No tools needed. The parts must be glued.
The kit is made of wood and has been lasered. This will cause the edges to look burnt and possibly leave traces of soot and smoke on the wood. These can be easily removed with fine sandpaper.
All components are laser cut so that there is a "beautiful" front and a marked, production-related "bad" back. Make sure that the good side always points to the visible side.
These soot and smoke marks as well as the fact that wood is a natural product, which is dimensionally influenced by basic physical laws such as temperature and humidity, there are certain limitations in the nature of the products, which must be consciously accepted.
We offer the most careful choice of material and the most modern production methods, nevertheless one has to accept with wood the peculiarities and unimpeachable characteristics, which are to be observed again and again in the practice - therefore these can not be claimed by the buyer as a material defect.
