Dolphin Lamp "Flipper"

Our sealing lape is named after the main actor of the TV series and films of the same name: the dolphin with the name Flipper.
After assambling, our wooden lamp shows the typical shape of a dolphin.
Depending on the kind of LED bulp used in the E14 socket, it emits a nice warm ambient light or, when using Filament LEDs, even casts the shadow of the dolphin into the room.
But even without the lighting, the dolphin always provides a pleasant and soothing sight when it floats almost weightlessly in the room.

The lamp can be easily pocketed or replaced with a folding mechanism. The screw socket allows height adjustment for longer illuminants.
(Attention, only use LED lamps as there is a risk of fire with normal filament lamps)

Here is some information about the namesake of the lamp:
The television series Flipper is based on the film character Flipper, a dolphin who had theatrical appearances in the films Flipper (1963), New Adventure with Flipper (1964) and later again in Flipper from 1996. There are two series; the original ran in three seasons from 1964 to 1967, the remake flippers new adventures in four seasons from 1995 to 2000.

Dimensions approx. 20 cm wide, 70 cm long and 31 cm high.

Item Description:

Material: 4mm wood
Weight: 0.800 kg
including E14 socket and connection cable

Delivery as 3D kit
We recommend fixing the individual components after positioning with glue.

We offer this lamp as a milled or lasered kit.

A) Lasered version:
 With a laser-cut kit, lasering causes the edges to look burnt and possibly leaving traces of soot and smoke on the wood. These can be easily removed with fine sandpaper.

B) Lasered & ground:
This kit was laser cut and then reworked by us so that the soot and smoke traces were removed from the surface. Nevertheless, dark rams remain at the cut edges.

C) Milled version:
In a milled kit, the edges and surfaces are clean and in typical wood color and surface.

Notes on machining with laser:
All components are laser cut so that there is a "beautiful" front and a marked, production-related "bad" back. Make sure that the good side always points to the visible side.

These soot and smoke marks as well as the fact that wood is a natural product, which is dimensionally influenced by basic physical laws such as temperature and humidity, there are certain limitations in the nature of the products, which must be consciously accepted.

We offer the most careful choice of material and the most modern production methods, nevertheless one has to accept with wood the peculiarities and unimpeachable characteristics, which are to be observed again and again in the practice - therefore these can not be claimed by the buyer as a material defect.