Cadillac Fleetwood 35 as 3D large modell
very oldtimer collector startet small. Here with our model of the Fleetwwod 1935 version you can start your collection on oldtimer 3D Models.
So dont wait and start today to build out of 197 parts your collection.
The Cadillac Fleetwood is a model of luxury car that was manufactured by the Cadillac division of General Motors between 1976 and 1996. The "Fleetwood" name was previously used as a prefix on several of Cadillac's models dating back to 1935. Four door cars bearing the name "Fleetwood" generally had longer wheelbases than Cadillac's more common Series 62 and DeVille models.
Through 1984, all Fleetwood series cars were rear wheel drive. For 1985, "Fleetwood" was used on new front wheel drive models which were made through 1992.
In 1987, a stretched wheelbase car was offered and named the Fleetwood 60 Special, a name which was last used in 1970 for the non-Brougham RWD Fleetwood car. During this time, the rear wheel drive cars built on the older Fleetwood platform dating from 1977 continued to be offered as "Fleetwood Brougham" later shortened to "Brougham". In 1993, a new rear wheel drive Fleetwood was introduced, but was discontinued after 1996.
Before 1934, all Cadillac models could be ordered with bodies built by General Motors' Fleetwood operation in Fleetwood, Pennsylvania, instead of their usual Fisher Body, and between 1935 and 1941, cars bearing the Fleetwood name were assembled there. It is from this association that the models received their name
Please note that this kit is not a toy and can only be used to a limited extent. Please keep the items away from small children under 6 years old. It involves breaking off small parts and being swallowed. We declare the model as a puzzle or decoration
Item Description:
Material: wood
Dimensions approx. 58,5' x 22,5 x 22,5 cm (LxWxH)
Weight approx: 1.8 kg
Content: 1 x lasered kit with all parts / assembly instructions
Supplied as a lasered kit. This must be assembled by yourself.
No tools needed. The parts must be glued.
The kit is made of wood and has been lasered. This will cause the edges to look burnt and possibly leave traces of soot and smoke on the wood. These can be easily removed with fine sandpaper.
All components are laser cut so that there is a "beautiful" front and a marked, production-related "bad" back. Make sure that the good side always points to the visible side.
These soot and smoke marks as well as the fact that wood is a natural product, which is dimensionally influenced by basic physical laws such as temperature and humidity, there are certain limitations in the nature of the products, which must be consciously accepted.
We offer the most careful choice of material and the most modern production methods, nevertheless one has to accept with wood the peculiarities and unimpeachable characteristics, which are to be observed again and again in the practice - therefore these can not be claimed by the buyer as a material defect.
